Management of essential tremor deep brain stimulation-induced side effects.

Deep brain stimulation (DBS) is an effective surgical therapy for carefully selected patients with medication refractory essential tremor (ET). The most popular anatomical targets for ET DBS are the ventral intermedius nucleus (VIM) of the thalamus, the caudal zona incerta (cZI) and the posterior subthalamic area (PSA). Despite extensive knowledge in DBS programming for tremor suppression, it is not uncommon to experience stimulation induced side effects related to DBS therapy. Dysarthria, dysphagia, ataxia, and gait impairment are common stimulation induced side effects from modulation of brain tissue that surround the target of interest. In this review, we explore current evidence about the etiology of stimulation induced side effects in ET DBS and provide several evidence-based strategies to troubleshoot, reprogram and retain tremor suppression.

Reproducibility Study of the Thermoplastic Resin Transfer Molding Process for Glass Fiber Reinforced Polyamide 6 Composites.

Polyamide 6 (PA6) thermoplastic composites have higher recyclability potential when compared to conventional thermoset composites. A disruptive liquid molding manufacturing technology named Thermoplastic Resin Transfer Molding (T-RTM) can be used for processing composites due to the low viscosity of the monomers and additives. In this process, polymerization, crystallization and shrinkage occur almost at the same time. If these phenomena are not controlled, they can compromise the reproducibility and homogeneity of the parts. This work studied the influence of packing pressure, as a process variable, throughout the filling and polymerization stages. To assess the process reproducibility and parts' homogeneity, physical, thermal and mechanical properties were analyzed in different areas of neat PA6 and composite parts. This study showed that a two-stage packing pressure can be successfully used to increase parts' homogeneity and process reproducibility. The use of 3.5 bar packing pressure during the polymerization stage resulted in mechanical properties with lower standard deviations, indicating a higher degree of homogeneity of the manufactured parts and higher process reproducibility. These results will be used for establishing the actual state of the technology and will be a base for future process optimization.

Can arbuscular mycorrhizal fungi and rhizobacteria facilitate 33P uptake in maize plants under water stress?

Arbuscular mycorrhizal fungi (AMF) and plant growth-promoting rhizobacteria (PGPR) are able to provide key ecosystem services, protecting plants against biotic and abiotic stresses. Here, we hypothesized that a combination of AMF (Rhizophagus clarus) and PGPR (Bacillus sp.) could enhance 33P uptake in maize plants under soil water stress. A microcosm experiment using mesh exclusion and a radiolabeled phosphorus tracer (33P) was installed using three types of inoculation: i) only AMF, ii) only PGPR, and iii) a consortium of AMF and PGPR, alongside a control treatment without inoculation. For all treatments, a gradient of three water-holding capacities (WHC) was considered i) 30% (severe drought), ii) 50% (moderate drought), and iii) 80% (optimal condition, no water stress). In severe drought conditions, AMF root colonization of dual-inoculated plants was significantly lower compared to individual inoculation of the AMF, whilst 33P uptake by dual-inoculated plants or plants inoculated with bacteria was 2.4-fold greater than the uninoculated treatment. Under moderate drought conditions the use of AMF promoted the highest 33P uptake by plants, increasing it by 2.1-fold, when compared to the uninoculated treatment. Without drought stress, AMF showed the lowest 33P uptake and, overall, plant P acquisition was lower for all inoculation types when compared to the severe and moderate drought treatments. The total shoot P content was modulated by the water-holding capacity and inoculation type, with the lowest values observed under severe drought and the highest values under moderate drought. The highest soil electrical conductivity (EC) values were found under severe drought in AMF-inoculated plants and the lowest EC for no drought in single or dual-inoculated plants. Furthermore, water-holding capacity influenced the total soil bacterial and mycorrhizal abundance over time, with the highest abundances being found under severe and moderate drought. This study demonstrates that the positive influence of microbial inoculation on 33P uptake by plants varied with soil water gradient. Furthermore, under severe stress conditions, AMF invested more in the production of hyphae, vesicles and spore production, indicating a significant carbon drain from the host plant as evidenced by the lack of translation of increased 33P uptake into biomass. Therefore, under severe drought the use of bacteria or dual-inoculation seems to be more effective than individual AMF inoculation in terms of 33P uptake by plants, while under moderate drought, the use of AMF stood out.

Distribution of Genes Related to Probiotic Effects Across Lacticaseibacillus rhamnosus Revealed by Population Structure.

The Gram-positive Lacticaseibacillus rhamnosus has been broadly reported as capable of exerting beneficial health effects. Bacterial genomic diversity may promote niche specialization, thus creating subpatterns within populations. As L. rhamnosus advantageous effects have been widely reported at strain level and few is known regarding the distribution of beneficial genes among L. rhamnosus strains, we investigated all publicly available genomes of Lactobacillus and Lacticaseibacillus genera to study the pangenome and general population structure of L. rhamnosus. Core genome multilocus sequence typing detected eight L. rhamnosus phylogroups (PG1 to PG8). L. rhamnosus harbors an open pangenome; PG1, PG3, PG4, and PG5 exhibited highly conserved gene distribution patterns. Genes significantly associated to the PG1, which comprises L. rhamnosus GG, are mainly phage-related. The adhesion operon spaCBA-srtC1 was found in 44 (24.7%) genomes; however, considering only the PG1, the prevalence was of 65%. In PG2 the spaCBA-srtC1 prevalence was of 43%. Nevertheless, both human and milk-derived strains harbored this operon. Further, two main types of bacteriocin clusters were found (Bact1 and Bact2). Bact1 predictions indicate the presence of garQ, encoding the class II bacteriocin garvieacin Q, that is mainly present in the closely related PG8A and a PG2 subcluster. PG2 harbors two distinct subclusters, harboring either spaCBA-srtC1 or Bact1. Our findings provide novel insights on the distribution of biotechnological relevant genes across L. rhamnosus population, uncovering intra-species patterns that may bring forth the development of more efficient probiotic products.